Teletek Electronics ECLIPSE 32 Engineer Programming Manual Teletek Electronics
Teletek Electronics ECLIPSE 32 Engineer Programming Manual Teletek Electronics ->>> https://fancli.com/2tzh4I
How to Program the Teletek Electronics ECLIPSE 32 Alarm Control Panel
The Teletek Electronics ECLIPSE 32 is a versatile and reliable alarm control panel that can protect up to 32 zones and 8 independent areas. It supports various types of detectors, periphery devices and communication modules. It can be programmed via a keyboard or a specialized software. This article will guide you through the basic steps of programming the ECLIPSE 32 using an LCD keyboard.
Step 1: Connect the LCD Keyboard to the System Bus
The LCD keyboard is a device that allows you to view and modify the settings of the ECLIPSE 32 control panel. It has a text display for detailed information of zones, troubles and arming type. It also has a built-in proximity card reader for access control. To connect the LCD keyboard to the system bus, follow these steps:
Turn off the power supply of the control panel.
Connect the red wire of the keyboard cable to the +12V terminal of the control panel.
Connect the black wire of the keyboard cable to the GND terminal of the control panel.
Connect the yellow wire of the keyboard cable to the DATA terminal of the control panel.
Connect the green wire of the keyboard cable to the CLK terminal of the control panel.
Turn on the power supply of the control panel.
Step 2: Enroll the LCD Keyboard to the Control Panel
The LCD keyboard needs to be enrolled to the control panel before it can be used for programming. To enroll the LCD keyboard, follow these steps:
Press and hold down both arrow buttons on the keyboard for 5 seconds until you hear a beep sound.
The display will show \"Enter address\". Enter a four-digit address for the keyboard using the numeric buttons. The address should be between 0001 and 0030 and should not be used by any other device on the system bus.
Press OK to confirm. The display will show \"Enter code\". Enter a six-digit engineer code using the numeric buttons. The default engineer code is 123456.
Press OK to confirm. The display will show \"Enrolling\". Wait until you hear another beep sound and see \"Enrolled\" on the display.
The LCD keyboard is now enrolled to the control panel and ready for programming.
Step 3: Enter Engineer Programming Mode
The engineer programming mode allows you to access and modify various parameters of the ECLIPSE 32 control panel. To enter engineer programming mode, follow these steps:
Press MENU on the keyboard. The display will show \"Enter code\". Enter a six-digit engineer code using the numeric buttons. The default engineer code is 123456.
Press OK to confirm. The display will show \"Engineer Menu\". You are now in engineer programming mode.
Step 4: Navigate Through Engineer Programming Menus
The engineer programming mode has several menus that correspond to different aspects of the ECLIPSE 32 control panel. You can use the arrow buttons on the keyboard to scroll through them. The menus are:
General Settings: This menu allows you to set general parameters such as date, time, language, backlight, etc.
Users: This menu allows you to add, edit or delete user codes and cards for access control.
Zones: This menu allows you to configure zone parameters such as type, name, area, delay, etc.
PGM Outputs: This menu allows you to configure output parameters such as type, name, activation, etc.
Areas: This menu allows you to configure area parameters such as name, arming mode, entry/exit delay, etc.
Timeslots: This menu allows you to configure time slots for auto arming and access control.
Communication: This menu allows you to configure communication parameters such as phone numbers, protocols, voice dialer, etc.
Peripheral Devices: This menu allows you to view and edit peripheral devices such as keyboards, expanders, wireless devices, etc.
To 061ffe29dd